AQUAvalve silicone

R7.00

Clear

Description

AQUAvalve silicone seals are inserted into the recesses in the top & bottom floats of the Autopot AQUAvalve.

The old AQUAvalve with its 3mm inlet uses the same (small) seal for both the top and bottom floats. (Blue or black colored valves)

The NEW AQUAvalve 5 with its 5mm inlet uses a small silicone seal for its top float and a larger silicone seal for its bottom float. (Grey colored valves)

PLEASE NOTE: Batches of silicone seals vary in color from time to time and they may be yellow, red, blue, etc. The function of these seals remain the same – to seal off the various floats that make up the working parts of the AQUAvalve.

At the end of your growing season clean the AQUAvalve using warm soapy water. Using an old tooth brush will help. The AQUAvalve is easily disassembled. The top float will slide all the way across and the bottom float is unclipped from its pivoting position. At this point it is advisable to remove the silicones to avoid them being lost.

Making sure your AQUAvalve floods and drains correctly is simply achieved and only takes a few seconds. Hold the AQUAvalve at eye level so that you can see the silicon fitted to the top float resting on the hole below it. The yellow silicon must create a tight seal when touching the hole. If it looks like it is not sitting parallel on the hole below simply lift the top float and apply pressure to one side of the silicon, drop the float and hold at eye level again. Repeat the procedure again if necessary.